HYDRAULIC PUMP DISCHARGE TUBE ASSEMBLY REPLACEMENT (Sheet 4 of 4)
By hand, install nut (K) on hose (L) onto elbow
(M). Using 1-1/2 inch wrench, tighten nut (K)
onto elbow (M).
With help from another person, start nuts (N)
and (P) on adapter (H) and valve (D).
Using 9/16 inch wrench and socket,
reassemble and install clamp (R) as shown.
Using 1-5/8 inch wrench to hold adapter (H),
use 1-1/2 inch wrench to tighten nut (P).
Using 9/16 inch socket with extension, install
clamp (S) and screw and new lockwasher (T)
onto hull mounting base.
Position clamp (U) over cables and using 7/16
inch socket with extension, install two screws
Push hose (W) on tube (X) and using
screwdriver, install clamp (Y) securing hose (W).
Refill hydraulic reservoir with oil (Item 43,
Close front hull drain valve (TM 9-2350-222-10).
Close turret platform access cover (TM
End of Task