HYDRAULIC PUMP DISCHARGE TUBE ASSEMBLY REPLACEMENT (Sheet 3 of 4)
16. Using 9/16 inch wrench and socket, remove two
washers (Z). Throw lockwashers away.
17. Remove bracket (V).
CLEANING AND INSPECTION:
Using rags and dry cleaning solvent (Item 54,
Check for damaged parts of tubes.
Replace damaged parts.
Lubricate threads and sleeves on tube assembly
Using 9/16 inch wrench and socket, install
bracket (A) with two screws (B), two new
Install valve (D) into tube (E) and start nut
(F) by hand.
Using 1-3/4 inch wrench to hold nut (G) on
valve (D), tighten nut (F) with 1-1/2 inch
Using 1-5/8 inch wrench on union (H) and
1-1/2 inch wrench on nut (J), install nut (J)
on union (H).
Install tube (E) under turret floor.
Go on to Sheet 4