REAR FLUID FILTER TUBE ASSEMBLY REPLACEMENT (Sheet 3 of 3)
Lubricate threads and sleeves with hydraulic oil
Remove covers from elbows (A) and (B).
Set tube (C) down onto elbow (B) and start nut
(D) onto elbow (B) by hand.
Aline tube (C) with elbow (A) and start nut (E)
onto elbow (A) by hand.
Using socket, install clamp (F) with screw and
new lockwasher (G).
Using wrench, tighten nut (E).
Using automotive wrench to hold elbow (B) and,
using wrench on nut (D), tighten nut (D) onto
Refill hydraulic reservoir with engine oil and
check for leaks (LO 9-2350-222-12).
Purge hydraulic system of air by raising and
lowering moldboard several times (TM
End of Task