TM 9-2350-222-20-1-5
HYDRAULIC RESERVOIR LINE FLUID FILTER REPLACEMENT (Sheet 5 of 8)
NOTE
If installing front filter, go to step
15.
INSTALLATION:
1.
Lubricate all threads, packings, and sleeves
with hydraulic fluid.
By hand, install nuts (A) and (B) onto elbows (C)
2.
and (D).
3.
Install new packings (E) onto elbows (C) and (D).
4.
Turn nuts (A) and (B) firmly down onto
packings (E).
5.
By hand, install elbows (C) and (D) into position
to connect with control valve tube and slipring
tube. Make sure nuts (A) and (B) turn with
elbows (C) and (D) until elbows (C) and (D) are
firmly set into filter ports.
6.
Position filter (F) onto mounting bracket and
using 7/16 inch socket and 7/16 inch wrench,
install three screws (G) and three nuts (H) into
filter (F) and mount.
7.
Aline tube (J) with elbows (D) and (K) and start
nuts (L) and (M) by hand.
NOTE
The following step will have to be
performed in the turret.
8.
Using 1-5/8 inch wrench on nut (B) and
adjustable wrench to hold elbow (D), tighten nut
(B).
9.
Using 1-1/2 inch wrench, tighten nut (L).
10.
Using 1-5/8 inch wrench to hold elbow (K) and
using 1-1/2 inch wrench on nut (M), tighten nut
(M).
Go on to Sheet 6
18-60