TM 9-2350-222-20-1-5
DRIVER'S SEAT SUPPORT AND HOUSING ASSEMBLY REPAIR (Sheet 4 of 7)
11.
Using retaining ring pliers, remove four
retaining rings (V) from each end of two
adjusting shafts (W).
12.
Remove two adjusting shafts (W).
13.
Remove adjusting assembly (K), housing (S), and
trip lever (X).
14.
Using hammer and punch, remove pin (Z) from
shaft (AA) in adjusting assembly (K).
15.
Remove shaft (AA).
CLEANING AND INSPECTION:
1.
Clean all parts using dry cleaning solvent (Item
2.
Inspect all parts for damage or wear. Replace
if required.
REPAIR:
Repair adjusting assembly and support
assembly by replacing worn or damaged parts.
Go on to Sheet 5
TA139237