TM 9-2350-222-20-1-5
DRIVER'S HATCH CUSHIONING PAD REPLACEMENT (Sheet 2 of 2)
4.
Weld ends of new pad to hull. Remove asbestos (TM 9-237).
NOTE
After welding procedures have been performed, complete the
following steps.
Using wire brush, clean all welded areas.
5.
Using primer paint (Item 50, Appendix D) and brush, prime all welded areas to be painted, inside
6.
and out.
7.
Using forest green paint (Item 46, Appendix D) and brush, paint all exposed outside areas of
vehicle which were affected by welding.
8.
Using white paint (Item 47, Appendix D) and brush, paint all exposed inside areas which were
affected by welding.
End of Task
TA140788
16-176