REAR DRAIN VALVE LINKAGE ADJUSTMENT (Sheet 3 of 7)
Adjust clevis (C) and jamnut (G) until one inch
of threads can be measured on rod (H).
10. Using wrench, tighten jamnut (G) while holding
clevis (C) with pliers.
11. Turn rod (H) until holes in clevis (C) and hole
in lever (E) can be lined up using clevis pin (B).
12. Using fingers, push clevis pin (B) through holes
in clevis (C) and hole in lever (E).
13. Using wrench, tighten rear coupling jamnut (J)
while holding coupling (K) with wrench.
Go on to Sheet 4