FRONT DRAIN VALVE ASSEMBLY REPLACEMENT (Sheet 2 of 5)
Using prybar, pry cage (D) from bottom of hull
(E). If cage (D) will not come off, hit knob (F)
with hammer until cage (D) comes out.
Using putty knife, scrape gasket (G) from cage
(D) and hull (E).
Clamp cage (D) in vise.
Using hammer and punch, drive pin (H) out of
hole in knob (F), while second person holds
spring (J) down using two screwdrivers. Throw
pin (H) away if damaged.
Remove knob (F), spring (J), and valve (K) from
With valve (K) in vise, using hammer and
punch, drive pin (L) out of hole in valve (K).
Throw pin (L) away if damaged.
Go on to Sheet 3