DRIVER'S HATCH DOOR ASSEMBLY AND SEALS (PASSIVE NIGHT VISION) REPAIR
(Sheet 3 of 5)
Insert new bushings (A) and (B) into hole (F)
until its flange is seated in hatch cover (C).
Using putty knife, apply thin coat of
grooves of door assembly (E).
Use care to keep adhesive in
groove only. Wait until adhe-
sive is tacky before installing
new packing (see instructions
Lay new seal (D) into grooves carefully
without stretching or compressing it.
Remove any excess adhesive on or near
seal (D) with dry cleaning solvent
Go on to Sheet 4