TM 9-2350-222-20-1-5
DRIVER'S HATCH SETSCREW ADJUSTMENT (Sheet 1 of 2)
3/4 in. combination box and open end wrench
9/16 in. combination box and open end wrench
Offset, flat-tip screwdriver
9/16 in. socket with 1/2 in. drive
5 in. extension with 1/2 in. drive
REFERENCE: TM 9-2350-222-10
ADJUSTMENT:
1.
Open driver's hatch (A).
2.
Traverse turret placing gun tube over right or
left center stowage box (TM 9-2350-222-10).
NOTE
If proper adjustment cannot be
made, refer to driver's hatch
torsion bar adjustment (page
3.
Locate left driver's hatch support housing
(B).
4.
Using 3/4 inch wrench, loosen jamnut (C).
5.
Using screwdriver, turn setscrew (D) to right
to raise hatch, or to left to lower hatch.
6.
Slide driver's hatch all the way to left to
make sure that it clears mounted M27
periscope.
7.
Using 3/4 inch wrench, tighten jamnut (C).
8.
Slide driver's hatch all the way to the right.
Go on to Sheet 2
TA140706