TM 9-2350-222-20-1-5
DRIVER'S HATCH TORSION BAR ANCHOR ADJUSTMENT (Sheet 5 of 6)
Place hatch torque adapter (C) on anchor
20.
nut.
Person in driver's station, apply forward
21.
pressure on adapter (C).
Person in turret, using 3/4 inch wrench,
22.
install screw (H) when hole 2 is alined
with hole in end housing (B).
Reposition hatch torque adapter (C) and
23.
apply forward pressure.
24.
Person in turret, using 3/4 inch wrench,
remove screw (H).
25.
Person in driver's station, apply enough
forward pressure to aline hole 1 with hole in
end housing (B), thus alining scribe mark
made in step 2.
26. Person in turret, using 3/4 inch wrench, install
screw and new lockwasher (H) securing anchor
(A) in position.
27. Remove hatch torque adapter (C).
Go on to Sheet 6
Change 4