TM 9-2350-222-20-1-5
DRIVER'S HATCH TORSION BAR ANCHOR ADJUSTMENT (Sheet 4 of 6)
16. Using pencil, make second mark, showing
anchor (A) to housing (B) position, for purpose
of installation without adjustment.
Remove anchor (A) from right end of housing
17.
(B).
NOTE
All rotations of anchor are
viewed from driver's seat.
NOTE
If you need to raise hatch, go to
step 18, then to step 20. If you
need to lower hatch, go to step
19.
18. To raise hatch, rotate anchor (A) one spline
tooth to right on torsion bar. Go to step 20.
.
19. To lower hatch, move anchor (A) to left spline
tooth on torsion bar.
Go on to Sheet 5
TA140703