FENDER AND SHIELD (REAR) REPLACEMENT (Sheet 5 of 7)
Install shield (B) to fender (M) and secure with three screws (N), six washers (P), and three new
self-locking nuts (R).
Using 9/16 inch socket on screw (N) and 9/16 inch wrench on nut (R), tighten screw (N) and nut (R).
If gap between stowage box base plate and outrigger exists,
shim gap with up to three plates.
7. Install outrigger No. 5 (S) using four screws (T) and new lockwashers (V).
Using 1-1/8 inch wrench, tighten four screws (T).
Go on to Sheet 6