TM 9-2350-222-20-1-5
FENDER AND SHIELD (REAR) REPLACEMENT (Sheet 1 of 7)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Installation
1-1/8 in. socket with 1/2 in. drive
TOOLS:
9/16 in. socket with 1/2 in. drive
7/16 in. socket with 1/2 in. drive
9/16 in. combination box and open end wrench
7/16 in. combination box and open end wrench
5 in. extension with 1/2 in. drive
1/2 in. combination box and open end wrench
Pry bar
Plates (8705499) (as required)
SUPPLIES:
Lockwasher (MS35338-51) (4 required)
Lockwasher (MS35338-46) (5 required)
Lockwasher (MS35338-44) (3 required)
Self-locking nut (MS51988-7) (7 required)
PRELIMINARY PROCEDURES:
REMOVAL
NOTE
Left rear fender and shield shown. Right rear removal is similar.
1.
Using 9/16 inch socket on five screws (A) and 9/16 inch wrench on nuts (B), remove five screws (A),
ten flat washers (C), five lockwashers (D), and nuts (B) holding fender (E) to angle (F) (hidden).
Go on to Sheet 2