OUTRIGGER SUPPORT NO. 4 (LEFT AND RIGHT) REPLACEMENT (Sheet 3 of 4)
CLEANING AND INSPECTION:
Inspect extension bracket and outrigger for
damage and cracks. Replace if defective.
2 . Inspect threaded holes and studs for
thread damage. Replace or repair if
Using 1-1/8 inch socket, install No. 3
outrigger (A) to hull support with four
screws (B) and new lockwasher (B.1).
Using torque wrench and 1-1/8 inch sock-
et, tighten screw 125-130 lb-ft (169-176
Using 3/4 inch socket and 3/4 inch wrench,
secure top flange of outrigger (A) to top of
hull support with two screws (C) and nuts (D).
Go on to Sheet 4