TM 9-2350-222-20-1-5
LOWER ENGINE ACCESS COVER REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
1.
Check lower engine access cover gasket for serviceability. If gasket must be replaced, but sticks to
cover (A) or bulkhead, using putty knife, rags, and dry cleaning solvent (Item 54, Appendix D)
remove gasket.
2.
If old gasket is not serviceable and is removed, using brush, apply adhesive to one side of new gasket.
3.
Stick new gasket into position on back of cover (A).
4.
Using brush, apply adhesive to bulkhead side of new gasket.
5.
Position cover (A) onto bulkhead.
Using socket, tighten four screws (B).
6.
7.
Using socket, install three screws, new lockwashers, and washers (C).
8.
End of Task
TA253564