CONNECTING LINK REPLACEMENT (Sheet 1 of 2)
5 in. extension with 1/2 in. drive
Slip joint pliers
7/16 in. socket with 1/2 in. drive
3/4 in. combination box and open end wrench
9/16 in. socket with 1/2 in. drive
Torque wrench with 1/2 in. drive (0-175 lb-ft) (0-237 N-m)
Cotter pin (MS24665-287)
Using pliers, remove cotter pin (A). Throw pin (A) away.
Using wrench, remove nut (B) and washer (C).
Using 7/16 inch socket and extension, remove screw (D) and washer (E).
Remove shield (F) and washer (G).
Using 9/16 inch socket, remove two bolts (H) from connecting rods (J) and (K).
Remove connecting rods (J) and (K) from link (L).
Using hands, remove connecting link (L) and washer (M) from shaft (N).
Go on to Sheet 2
15-28 Change 1