TM 9-2350-222-20-1-4
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 5 of 13)
NOTE
When adjusting all steering rod end bearings, steering rods
must go into steering rod and sleeves past check holes. When
wire will not go through the check holes, there are sufficient
threads remaining.
Using 9/16 inch wrench, loosen jamnuts (H)
9.
and (J).
10. Using 9/16 inch wrench, remove screw (E).
11. Remove steering rod end bearings from clevis. Insert locating pin (B).
12. Using 9/16 inch wrench on steering rod end bearings flats (K) and (L), turn clockwise or
counterclockwise until steering rod end bearing (F) and clevis (G) holes line up and steering rod
bearing (M) and clevis (N) holes line up (one end at a time).
13. Place steering rod end bearings (F) and (M) into clevis (G) and (N).
Go on to Sheet 6
TA140519
15-6