TM 9-2350-222-20-1-4
TRACK ASSEMBLY REPLACEMENT (Sheet 9.1 of 10)
NOTE
If P.D. 704 torque wrench kit is
a v a i l a b l e , go to step 49. If not
available, go to step 42.
Have other person start engine (TM
42.
9-2350-222-10). Slowly drive tank until the
track link in front of the end connectors (G),
just installed, is fully engaged over the
compensating idler wheel and the track link
after end connectors (G) is just touching the
compensating idler wheel.
43. Using torque wrench with 15/16 inch socket,
tighten end connector wedge (J) bolts to
180-200 lb-ft (244-271 N-m).
Move tank until end connector (G) is in lower
44.
position.
Move tank until end connector (G) is located in
45.
same position as step 42. Using torque wrench,
tighten to 180-200 lb-ft (244-271 N-m).
46. Repeat steps 42 thru 44 until torque stays at
180-200 lb-ft (244-271 N-m).
47. Move tank until centerguide (N) is between
compensating idler wheel and No. 1 roadwheel
position.
48. Using torque wrench, tighten centerguide nut
(P) to 350-380 lb-ft (474-515 N-m).
Go on to Sheet 9.2
14-90 Change 5