TRACK ASSEMBLY REPLACEMENT (Sheet 2 of 10)
Disconnect track up front between
idler wheel and
roadwheel at position No. 1 (on
Using 15/1 6 inch socket with ratchet,
loosen bolt (A) securing wedge (B) to end
Using hammer, tap wedge (B) to loosen
Remove bolt and wedge. Throw both
Repeat steps 1 thru 3 to remove bolt and
wedge at opposite side of track.
Put hook (D) of puller and pump behind.
end con nector (C).
Aline studs (E) of puller with shoe pins
Pump handle (G) until gap between end
connector (C) and track shoes (H) is about
Go on to Sheet 3
14-82 Change 5