TM 9-2350-222-20-1-4
TRACK SUPPORT ROLLER REPLACEMENT (Sheet 8 of 11)
6.
On other support rollers, using hammer, tap new spring pin (D) through hole in housing and axle
(A).
7. Make sure space (E) is correctly installed on axle (A),
NOTE
Open groove of deflector (F) and
lip seal (G) must face outward.
8.
Mount deflector (F) and new seal (G) over
axle (A).
9.
Using hammer and oil seal replacer
(Item 21, Chapter 3, Section I), tap
deflector and seal into place.
10.
Pack inner bearing cone (H) with grease (Item 36, Appendix D).
11.
Pack outer bearing cone (J) with grease (Item 36, Appendix D).
Go on to Sheet 9
TA141323
Change 1 14-41