ROADWHEEL ARM REPAIR (Sheet 7 of 9)
Position bearing (E) on arm (B).
Secure bearing tool assembly (Item 17,
Chapter 3, Section I) to bearing (E)
with screw and nut. Install puller to
bearing tool assemly and drive bearing
(E) in arm until centered. Remove
bearing tool assembly and puller.
Stake bearing (E) to arm (B) at three
equally spaced locations on each side
of bearing (E). Go on to step 8.
I d e n t i f y FRONT and BACK of outer grease seal. Rubber
g r e a s e seal retaining lip can be pulled away from metal
inner edge on FRONT of seal. pull back retaining lip on seal
and expose garter spring. BACK of seal has rubber grease
retainer bonded to metal ease and connot be pulled away.
OUTER GREASE SEAL
Go on to Sheet 8