BRAKE NIPPLE AND HOSE ASSEMBLY REPLACEMENT (Sheet 5 of 6)
Remove plastic Plugs from tube assemblies (E) and (F) and position assembled parts (A) thru (D)
with tee (D) between tube assemblies (E) and (F).
Tighten nuts of tube assemblies (E) and (F) to tee (D) finger tight.
Remove screw (G) and lockwasher (H) holding
adjusting screw lock plate. Throw lockwasher away.
Position bracket (B) over adjusting screw lock
plate and insert screw (G) and new lockwasher
(H). Tighten finger tight.
Using 9/16 inch socket, tighten screw (G).
Using 11/16 inch wrench, tighten nuts of tube
assemblies (E) and (F).
Using 11/16 inch wrench, tighten nut of tee (D).
Thread nut of tee (J) on nipple (A) finger tight.
With tee (J) facing as shown, use 13/16 inch
wrench to hold nipple (A) and 11/16 inch
wrench to tighten nut of tee (J). Tighten nut.
Go on to Sheet 6