TM 9-2350-222-20-1-4
BRAKE NIPPLE AND HOSE ASSEMBLY REPLACEMENT (Sheet 2 of 6)
REMOVAL:
1.
Place rags under hose assembly (A) to absorb
brake fluid.
2.
Using adjustable wrench to hold elbow (B) and
11/16 inch wrench on nut of tube assembly (C),
disconnect nut.
Insert plastic plug in nut of tube assembly (C).
3.
4.
Using 11/16 inch wrench' on nut of hose
assembly (A) at tee (D), disconnect nut and
remove hose assembly (A) and elbow (B).
5.
Using adjustable wrench to hold elbow (B) and
11/16 inch wrench on nut of hose assembly (A),
disconnect nut and remove elbow (B).
NOTE
If hose assembly (A) is not defective, insert plastic plugs in
end fittings.
6.
Using 11/16 inch wrench on nuts of tube assemblies (E) and (F), disconnect nuts.
Go on to Sheet 3
TA140362
13-55