BRAKE MASTER CYLINDER MOUNTING BRACKET AND PUSH ROD REPLACEMENT
(Sheet 7 of 7)
Aline holes in master cylinder with those in
Place new lockwasher (S) on five screws (T),
insert screws, and tighten finger tight.
Using 9/16 inch socket, tighten five screws (T).
Place new lockwasher (U) on screw (V), insert screw, and tighten finger tight.
Using 7/16 inch socket, tighten screw (V).
Slip boot (H) over lip of master cylinder.
Remove webbed strap from master cylinder and harness mounting bracket.
Install personnel heater duct (page 19-1 1).
Place shift lever in P (park) position and remove blocks from track (TM 9-2350-222-10).
End of Task