TM 9-2350-222 -20-1-4
2 of 4)
Connect filler and bleeder (B) to master
cylinder filler port (C).
Filler and bleeder will maintain pressure. Fill master cylinder with fluid.
Using 3/8 inch wrench, open bleeder valve (D) on master cylinder (E). Let hydraulic fluid run
until no air bubbles are detected in hydraulic fluid. Close bleeder valve (D).
Using 11/16 inch wrench on nut (F) and 3/4 inch wrench on adapter (G), loosen nut (F) and bleed
gage (H) until no air bubbles are observed in hydraulic fluid. Tighten nut (F) holding adapter (G).
Steps 7 thru 9 require one person at driver's station and one
person at rear of vehicle.
Go on to Sheet 3