FINAL DRIVE VENTING SYSTEM REPLACEMENT (Sheet 3 of 10)
Using 9/16 inch wrench, disconnect tube assembly (H) from tee (C).
Using 13/16 inch wrench to hold adapter (J), use 9/16 inch wrench and disconnect tube assembly (H)
Using 7/16 inch wrench, remove two screws (K) and lockwashers (L) securing clamps (M). Throw
10. Remove tube assembly (H) and clamps (M) from vehicle.
11. Remove clamps (M) from tube assembly (H).
12. Using adjustable wrench, remove tee (C) from left final drive.
13. Using 11/16 inch wrench to hold tube assembly (N), use 13/16 inch wrench and remove adapter (J).
Go on to Sheet 4
12-22 Change 1