TM 9-2350-222 -20-1-4
FINAL DRIVE STUD REPLACEMENT (Sheet 1 of 2)
TOOLS: 1-1/2 in. open end wrench (2 required)
Pipe wrench (2 in. opening)
Ruler
Hammer
SUPPLIES :
primer (Item 48, Appendix D)
Sealing compound (Item 26, Appendix D)
Small brushes (Item 10, Appendix D) (2 required)
Penetrating oil (Item 42, Appendix D)
PRELIMINARY PROCEDURE:
NOTE
REMOVAL:
Studs come in three different
NOTE
Make sure you order
lengths.
right size.
If stud is bent or cracked, go to
If stud has damaged
step 1.
threads or is broken off below
threads. go to step 2.
If stud is broken off flush with
final drive housing notify
support maintenance.
-
1.
Apply penetrating oil (Item 42, Appendix D) to
base of stud (A). Thread two hex nuts on stud
(B) and jam the nuts. Sharply tap head of stud
(R)several times. with hammer. Turn lower nut
....
(C) to remove stud.
Go on to Sheet 2
TA140299
12-6