TRANSMISSION WIRING HARNESS REPLACEMENT (Sheet 1 of 7)
TOOLS: 3/4 in. combination box and open end wrench
7/16 in. combination box and open end wrench (2 required)
Slip joint pliers
9 /16-in. socket with 1/2 in. drive
3/4 in. socket with 1/2 in. drive
SUPPLIES: Identification tags
PRELIMINARY PROCEDURE: Remove powerplant (page 5-1)
Perform steps 1 t h r u 9 if transmission
is mated to a 2D engine.
perform steps 1, 2, and 3, and 10 thru 14
if transmission is mated to a 2A engine.
Locate and tag six connections (male and
female) (A) through (F) for identification.
Using hands, unplug connections (A)
Using pliers, disconnect connector (F).
Go on to Sheet 2