TM 9-2350-222-20-1-4
ENGINE WIRING HARNESS REPLACEMENT (2D ENGINE) (Sheet 2 of 12)
REMOVAL:
Using flat-tip screwdriver and 3/8 inch wrench,
1.
Throw lockwashers away.
2.
Remove engine harness (B) from mounting
bracket (C).
3. using 7/16 inch socket, remove eight screws (D)
Throw lockwashers away.
4.
Remove four clamps (G) from engine.
NOTE
Engine wiring harness is wrapped,
while other two harness leads are
covered with insulation.
Separate and remove engine wiring harness (B)
5.
from top of engine.
Go on to Sheet 3
TA139891
10-340