TM 9-2350-222.20-1-4
ENGINE OIL HIGH TEMPERATURE SWITCH REPLACEMENT (2D ENGINE) (Sheet 2 of 2)
REMOVAL:
1.
Place rags under switch.
2.
Pull socket of rubber insulated connector (A) from switch cap (B).
3.
Using socket, remove switch (C) from engine.
INSTALLATION:
1.
Lightly coat threads of switch with sealing compound (Item 20, Appendix D).
2.
Using socket, install switch (A) into engine.
Push socket of rubber insulated connector (B)
3.
into switch cap (C).
4.
Remove rags from under switch
5.
Connect engine for powerplant ground hop (page 5-48).
6.
Start and run engine. Observe temperature indicator for normal oil temperature(TM 9)
2350-222-10).
7.
Shut down engine. Disconnect engine from powerplant ground hop (page 5-62).
8.
Install powerplant (page 5-37).
End of Task
TA139814
10-263