HEADLIGHT ADJUSTMENT (Sheet 2 of 2)
Turn on service drive headlights, low beam (TM
Center of maximum light intensity should be
centered on line (D).
If not, using 9/16 inch wrench, loosen three
screws (G) and adjust by tilting headlight (H) to
headlights in same manner.
Using 9/16 inch wrench, tighten three screws
Check to see if light intensity for left headlight
is centered on intersection of lines (D) and (E).
If not, using 7/16 inch wrench, loosen three
screws (J) at base of headlight.
Turn headlight (H) until in proper position.
Using 7/16 inch wrench, tighten three screws
(J) when adjusted.
Repeat steps 13 through 16 for right headlight,
using lines (D) and (F).
Turn off lights (TM 9-2350-222-10),
End of Task