RIGHT TAILLIGHT - STOPLIGHT ASSEMBLY REPLACEMENT (Sheet 1 of 3)
TOOLS: 9/16 in. combination box and open end wrench
SUPPLIES: Silicone compound (Item 32, Appendix D)
Masking tape (Item 57, Appendix D)
Lockwasher (MS35338-46) (2 required)
Remove transmission shroud (page 9-19)
CONNECTIONS FOR RIGHT
Inspect leads (A) and leads (B) for
numbered tags (C) 23 and 24. If
l e a d s do not have tags, use
masking tape (Item 57, Appendix
D) and pencil to number leads.
Reach through exhaust door opening and
disconnect two leads (A) from hull connectors
Slide two connector shells (D) back on taillight
leads to expose two slotted washers (E).
Lubricant may be needed on leads
(A) to remove shells (D).
Remove two slotted washers (E) and two shells
GO on to Sheet 2