MASTER CONTROL PANEL REPAIR (Sheet 61 of 65)
Master Control Panel Wiring Harness Replacement (Sheet 5 of 5)
Connect lead (circuit 400) to master heater switch (L).
Connect lead (circuit 27) to gage circuit breaker (M).
10. Connect lead (circuit 486) to manifold preheat circuit breaker (N).
11. Connect lead (circuit 76A) to fuel pump circuit breaker (P).
Connect lead (circuit 54) to fuel shutoff circuit breaker (Q).
Connect lead (circuit 38/516A) to IR power circuit breaker (R).
Connect leads (circuit 920) to bilge pump and gas particulate circuit breaker (S).
Using socket, install two flat washers (T), new lockwashers (U), and nuts (V) securing two harness
junctions (W) to panel.
End of Task