TM 9-2350-222-20-1-4
MASTER CONTROL PANEL REPLACEMENT (Sheet 3 of 4)
Separate electrical connector (K), circuit
6.
number 15, by pulling apart.
7.
Using fingers, disconnect electrical connector
(L), circuit number 19, from center of switch
(M) by pulling out.
Remove panel (E) from vehicle.
8.
INSTALLATION:
1. Position new master control panel (A) in
vehicle just below mounting bracket so that
back of panel is accessible.
2. Using hand, connect connector (B) to back of
control panel (A).
Connect electrical connector (C), circuit 19, to center of switch (D) by pushing in.
3.
4.
Connect electrical connector (E), circuit 15, by pushing together.
Go on to Sheet 4
TA139606
10-50