TM 9-2360-222-20-1-3
FAN DRIVE OIL SEAL REPLACEMENT (Sheet 3 of 5)
NOTE
Place housing on boards before driving out seal.
Using hammer and brass drift, drive out oil seal (G) from housing (E) and throw seal away.
5.
Clean housing (E) with dry cleaning solvent (Item 54, Appendix D) and rags and remove any dried
6.
adhesive and oil.
INSTALLATION:
1.
Using putty knife, coat sides of replacement oil seal with sealing compound (Item 24, Appendix D).
Use care to prevent sealing compound from contacting felt part of seal.
2.
Position new oil seal (A) in housing with lip of seal toward gasket surface of oil seal housing (B).
TA141282
Go on to Sheet 4
9-64