TM 9-2360-222-20-1-3
ENGINE COOLING FAN SHROUD REPLACEMENT (Sheet 7 of 8)
10. Position two pieces of fan housing (J) onto powerplant.
Using two 9/16 inch wrenches, install two screws, washers, and new self-locking nuts (K) securing
two pieces of fan housing (J) together.
12.
Using 9/16 inch socket, install four screws and new lockwashers (L) securing fan housing (J) to fan
shroud (A).
13.
Using hands, position fan (M) onto engine.
14.
Using 1-1/4, inch socket, install washer (N) and
nut (P) securing fan (M) to engine.
15.
Using 1-1/4 inch socket and torque wrench,
tighten nut (P) to 50-55 lb-ft (68-75 N-m).
16.
Back nut (P) off until slot in nut (P) alines with
hole in shaft. Using pliers, install new cotter
pin (Q).
Go on to Sheet 8
TA140291
9-57