LEFT EXHAUST EJECTOR TUBE REPLACEMENT (Sheet 3 of 4)
Position insulation (A and B) to ejector
Using cross-tip screwdriver and 5/16 inch
wrench, install 11 screws (D), 22 flat
11 nuts (G) to secure insulation (A and B)
to ejector tube (C).
Position packing (H) and clamp (J) onto
ejector tube (C). Use flat-tip screwdriver
to tighten clamp (J).
Apply a light coat of silicone compound
(Item 32, Appendix D) to end of two
Position left exhaust ejector tube (C)
and new gasket (L) onto studs of turbo-
supercharger housing (M).
Using 9/16 inch wrench, install six new
self-locking nuts (N) to secure left exhaust
ejector tube (C) to turbosupercharger
ENGINE LEFT BANK
Go on to Sheet 4