EXHAUST PIPE CAP ASSEMBLY REPLACEMENT (Sheet 3 of 3)
Position tube cover (A) onto top of tube (B)
with mounting holes of tube cover (A) alined
with mounting holes in tube (B).
Insert two spacers (C) into holes in top of
tube cover (A).
Insert bolt (D) through spacer (C), tube cover
(A), tube (B), tube cover (A), and spacer (C).
Start new self-locking nut (E) onto bolt (D).
Using two wrenches, tighten nut (E) to bolt
Position notch of cap assembly into notch of
exhaust pipe (F) at same inward angle as
Position clamp (G) onto bottom of cap
assembly and exhaust pipe (F). Latch clamp
together with bolt (H).
Using wrench, tighten nut (J) on clamp (G) to
hold cap assembly to exhaust pipe (F).
Close engine exhaust doors (TM
End of Task