ACCELERATOR TUBE ASSEMBLY REPLACEMENT (Sheet 4 of 4)
Push tube (D) through hole in bracket (J).
Install pin (K) in clevis (L) and lever (M) while pushing tube (D) toward front of vehicle.
Using pliers, install new cotter pin (N) in pin (K).
Screw jamnut (P) all the way on tube (D).
Screw clevis (Q) on tube (D) the recorded number of turns.
Using torque wrench and crowfoot wrench, tighten jamnut (P) against clevis (Q) to 13-15 lb-ft
(18-20 Nm) while holding clevis (Q) with Pliers
Install pin (R) in clevis (Q) and lever (S).
Using pliers, install new cotter pin (T) on pin (R).
Press accelerator foot pedal and make sure linkage operates smoothly. If linkage does not operate
smoothly, replace any missing parts and remove things in the way.
Install fixed fire extinguisher cylinder, if cylinder was removed (page 21-51).
End of Task