TM9-2350-222-20-1-3
ACCELERATOR LEVER ASSEMBLY REPLACEMENT (Sheet 2 of 3)
Remove washer bearing (N) from support (M).
7.
8.
Using socket, remove two screws (P), lockwashers (Q), and cable clamp (R). Throw lockwashers
away.
Remove support (M) from vehicle.
9.
Inspect bearing in lever (L). If bearing is defective, use hammer and drive pin punch and drive
10.
bearing out of lever (L).
CLEANING AND INSPECTION:
1.
Clean all parts using dry cleaning solvent (Item 54, Appendix D), and clean rags (Item 65,
Appendix D).
2.
Inspect all parts for cracks, bends, wear, and other defects.
INSTALLATION:
1.
Line up holes in bracket (A), clamp (B), and
support (C).
2.
Using fingers, install two screws (D) and new
support (C).
3.
Install washer bearing (F) on support (C).
Go on to Sheet 3
7-436