MANIFOLD HEATER INPUT SOLENOID VALVE AND FUEL LINE REPLACEMENT
(Sheet 10 of 10)
Input Solenoid Valve Replacement (Sheet 5 of 5)
Position solenoid valve (B) and fuel filter (E) with attached fittings to brackets on engine.
Install two screws (H) with new lockwashers and flat washers to secure fuel filter (E) to engine
bracket. Using screwdriver, tighten screws.
Install two screws and washers (J) to secure solenoid valve (B) to bracket. Using 5/16 inch
wrench, tighten screws.
Connect two fuel lines (K) to tee (C), Using 7/16 inch wrench, tighten fuel line nuts.
Connect hose assembly (L) to adapter (M). Using 1/2 inch and 5/8 inch wrenches, tighten hose
nut to adapter.
Connect electrical lead (N) to solenoid valve (B).
Operate primer pump (TM 9-2350-222-10). Check for leaks. If leaks are found, tighten connections
Install 2A powerplant (page 5-14) or 2D powerplant (page 5-37).
End of Task