TM 9-2360-222-20-1-3
MANIFOLD HEATER IGNITION COIL AND CABLE REPLACEMENT (2D ENGINE)
(Sheet 3 of 3)
INSTALLATION:
Position two clamps (A) onto coil (B).
1.
Position coil (B) and clamps (A) on frame.
2.
Install two screws (C) to secure clamps (A) to
3.
frame. Do not tighten.
4.
Connect cable (D) to coil (B).
Using 7/8 inch wrench, tighten lead.
5.
Using 1/2 inch socket and 1/2 inch wrench,
6.
install two screws (E) to hold bracket (F) to
frame.
Using 7/16 inch socket, install two screws (G)
7.
and clamp (H) to bracket (F).
Route cable (D) over bracket and connect to
8.
spark plug (J).
9.
Using 3/4 inch wrench, tighten cable (D).
10. Using 1/2 inch socket, tighten screws (C).
11. Alining keyway, connect electrical connector
(K) to coil (B).
12. Using spanner wrench, tighten electrical
connector (K).
13. Perform manifold heater operational check
End of Task
TA148944
7-396