TM 9-2360-222-20-1-3
MANIFOLD HEATER RETURN FUEL CHECK VALVE REPLACEMENT (Sheet 1 of 3)
TOOLS: Wrench set (combination box and open end 5/16 in. thru 1 in. openings)
Wire brush
SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I)
SUPPLIES: Drain pan
Sealing compound (Item 28, Appendix D)
Filtering disc (11610365) (2D engine only)
REFERENCES: TM 9-2350-222-10
PRELIMINARY PROCEDURES: Remove powerplant (page 5-1)
REMOVAL:
CAUTION
When removing or installing fuel lines, care must be taken not
to damage fittings and threads or twist or distort fuel lines or
hoses.
NOTE
I t may be necessary to use two wrenches for removal or
installation of hoses and tubes.
Go on to Sheet 2
TA141554
7-373