MANIFOLD HEATER NOZZLE REPLACEMENT (Sheet 3 of 3)
On 2D engines, install new filter
between bushing (A) and nozzle (B)
a n d new filtering disc between
elbow (D) and nozzle.
Using 13/16 inch and 5/8 inch wrenches, install
bushing (A) in new nozzle (B).
Using 5/8 inch and 7/16 inch wrenches, install
elbow (C) to bushing (A).
Using 7/16 inch wrench, install elbow (D) into
Install nozzle (B) and fittings into manifold
Aline nozzle for ease of connecting fuel lines.
Using 1 inch wrench, tighten jamnut (F).
Using two 7/16 inch wrenches, connect inlet
fuel line (G) to elbow (C).
Using 7/16 inch and 9/16 inch wrenches, install
return fuel line (H) to elbow (D).
Perform manifold heater operational check
End of Task