MANIFOLD HEATER NOZZLE REPLACEMENT (Sheet 2 of 3)
Using two 7/16 inch wrenches, disconnect fuel
inlet line (A) from elbow (B).
Using 7/16 inch and 9/16 inch wrenches,
disconnect fuel return line (C) from elbow.
Using 1 inch wrench, loosen jamnut (D).
Using 13/ 16 inch wrench, remove nozzle (E) and
fitting from manifold heater (F).
Using 7/16 inch wrench, remove elbow (G)
and (if present) filtering disc from nozzle.
Throw filtering disc away.
Using 5/8 inch and 7/16 inch wrenches,
remove elbow (B) from nozzle.
Using 5/8 inch and 13/16 inch wrenches,
remove bushing (H) and (if present) filtering
disc. Throw filtering disc away.
Throw nozzle (E) away.
Inspect all parts disconnected or removed.
Replace all items as necessary.
Go on to Sheet 3