FUEL-WATER SEPARATOR FILTER ELEMENT REPLACEMENT (Sheet 5 of 6)
The following steps require assistance of second person
located at driver's station.
10. Remove engine upper access cover (page 16-40).
11. Locate fuel-water separator (D), and using 7/16
inch wrench, loosen bleeder valve (L). Do not
12. Person in driver's station set FUEL PUMPS
switch (M) to ON and MASTER BATTERY
switch (N) to ON (TM 9-2350-222-10).
Person at fuel-water separator observe for air
release (bubbles) from bleeder valve (L).
14. Person in driver's station set MASTER
BATTERY switch (N) to OFF (TM
Go on to Sheet 6