TM9-2350-222-20-1-3
FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE)
(Sheet 8 of 8)
3.
Set MASTER BATTERY switch to ON (TM
9-2350-222-10). Watch fuel-water separator
bleed cap (A) for air release (bubbles).
4.
Set MASTER BATTERY switch to OFF (TM
9-2350-222-10). After about one minute,
repeat step 3.
NOTE
It may be necessary to perform
steps 4 and 5 several times until
a consant fuel flow (no bubbles)
from
the
bleed
cap
(A)
is
observed.
5.
Check for leaks and tighten or replace components as necessary.
6.
Using 7/16 inch wrench, turn fuel-water separator bleed cap (A) to the right until snug,
7.
8.
Set FUEL PUMPS switch to OFF (TM 9-2350-222-10),
Set MASTER BATTERY switch to OFF (TM 9-2350-222-10).
10.
11.
End of Task
TA148900
7-321