TM9-2350-222-20-1-3
FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE)
(Sheet 6 of 8)
CAUTION
Be careful not to strike ends of
sensors
during
installation or
damage may result.
NOTE
Straight edge of mounting plate
(G) must be installed to the right
against the fuel-water separator.
5.
Manually connect solenoid valve electrical lead
(D) to fuel-water separator control assembly (A).
6.
Manually connect engine electrical harness
connector (E) to fuel-water separator control
assembly (A).
7.
Using screwdriver, install two screws and two
cushioned clamps (F) and mounting plate (G) at
right side and above fuel-water separator
control assembly.
8.
Using 9/16 inch wrench, install lower (shorter)
sensor (H) to fuel-water separator filter.
9.
Using 9/16 inch wrench, install upper (longer)
sensor (J) to fuel-water separator filter.
GO on to Sheet 7
7-319