TM 9-2350-222-20- 1-3
FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE)
(Sheet 1 of 8)
PROCEDURE INDEX
PAGE
PROCEDURE
.
Removal
Installation
Test
7/16 in. combination box and open end wrench
Hammer
TOOLS:
9/16 in. combination box and open end wrench
5/16 in. socket with 1/2 in. drive
1/2 in. combination box and open end wrench
1/2in. socket with 1/2 in. drive
Flat-tip screwdriver
6 in. extension with 1/2 in. drive
Slip joint pliers
5/16 in. combination box and open end wrench
1/8 in. drive punch
SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I)
SUPPLIES: Drip pan
Lockwasher (MS35338-45) (3 required)
PERSONNEL: Two
REFERENCE: TM 9-2350-222-10
PRELIMINARY PROCEDURE:
Go on to Sheet 2
TA148893
7-314